SC 430 V8-4.3L (3UZ-FE) (2003)
/Page-303005.png)
30. INSPECT BEARING BACKLASH
a. Using a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the specified maximum, replace the bearing.
31. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the deviation exceeds the specified maximum, replace the axle hub.
32. INSTALL REAR DISC
33. INSTALL DISC BRAKE CYLINDER ASSY REAR LH
a. Install the brake cylinder to the steering knuckle with the 2 bolts.
Torque: 104 Nm (1,065 kgf-cm, 77 ft. lbs.)
34. INSPECT PARKING BRAKE SHOE LINING THICKNESS
35. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO.2 LH
36. INSTALL REAR WHEEL
a. Install the rear wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Install the ornament with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)
37. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
38. SPEED SENSOR SIGNAL CHECK
