Aviator 2WD V8-4.6L DOHC (2003)
Part 2 Of 2
3. Remove the components in the order indicated in the illustration and table.
4. To install, reverse the removal procedure.
Item 2: Front Disc Brake Caliper Anchor Plate, Caliper, and Pads Removal Note
1. CAUTION: When removing the front disc brake components, never allow them to hang from the brake hose.
Using mechanic's wire, secure the front brake components.
Item 3: Front Disc Removal Note
1. Match mark the front disc and front wheel hub flange before removing the front disc.
Item 4: Harness Connector Removal Note
1. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Lower the vehicle.
Item 5: Harness Retainers Removal Note
1. Raise the vehicle on a hoist.
Item 8: Sensor Ring Removal Note
1. The sensor ring is integral to the front wheel hub and bearing assembly and cannot be serviced.