Aviator 2WD V8-4.6L DOHC (2003)
4. Remove the components in the order indicated in the illustration and table.
5. To install, reverse the removal procedure.
^
Fill and bleed the cooling system.
Item 4: Condenser Inlet Tube Removal Note
1. Release the condenser inlet tube from the retaining clips and position aside.
Item 7: Condenser Outlet Tube Removal Note
1. Disconnect and position aside.
Item 8: Transmission Oil Cooler Lines Removal Note
1. NOTE: If equipped, remove the safety retainer from the connectors.
Using the special tool, disconnect the quick couplers.
Item 11: Cooling Module Removal Note
1. Lift the cooling module Lip and toward the engine to remove it from the vehicle.
Item 8: Transmission Oil Cooler Lines Installation Note
1. NOTE: If equipped, install the safety retainer on the connectors.
Connect the fittings and pull on them to make sure they are fully engaged.
Item 7: Condenser Outlet Tube Installation Note
1. Install new O-rings lubricated in clean PAG oil.