Aviator 2WD V8-4.6L DOHC (2003)
Illustration 2 Of 2
5. Illustration 2 of 2. Remove the components in the order indicated in the illustration and table.
Item 3: Clamp Removal Note
1. Using a suitable tool, clamp-off and disconnect the heater hoses.
-
After disconnecting the heater hoses, allow the coolant to drain from the auxiliary heater core to avoid coolant spilling inside the passenger
compartment.
INSTALLATION
1. To install, reverse the removal procedure.
2. Lubricate the refrigerant system with the correct amount of clean PAG oil.
3. Fill the engine cooling system.
4. Evacuate, leak test and charge the refrigerant system.
