Aviator 2WD V8-4.6L DOHC (2003)
1. Push the retainers together and separate the rear ramp from the sheet metal.
Item 13: Safety Canopy Removal Note
1. Remove the safety canopy.
1
Push the safety canopy cover in, releasing it from the front ramp lower retainers and rotate the bottom of the safety canopy up and out of the
ramp.
2
Separate the safety canopy from the front ramp upper retainers.
3
Remove the safety canopy.
Item 14: Front Ramp Removal Note
1. Push the retainers together and separate the front ramp from the sheet metal.
INSTALLATION
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, and notes at the beginning of the removal
procedure.
1. WARNING:
-
Before installing a safety canopy module, inspect the roofline for any damage. If necessary, the sheet metal must be reworked to its
original condition and structural integrity. Install new fasteners if damaged and remove foreign objects. Failure to do so can result in
personal injury in the event of a safety canopy deployment.
-
Inspect the safety canopy before installation. If the safety canopy is damaged or the cover has separated and the canopy material has
been exposed, a new safety canopy module must be installed. Do not attempt to repair the safety canopy module. Failure to follow
these instructions can result in personal injury in the event of a safety canopy module deployment.
-
Never put any type of fastener or tie strap around any part of the safety canopy module or interior trim panel. This will prevent the
