Aviator 2WD V8-4.6L DOHC (2003)
Disarming/Service and Repair/Prove Out Procedure
Item 6: A-Pillar Tether Pin-Type Retainer Installation Note
1. If reusing the same safety canopy, route the tether through the pin-type retainer. If a new safety canopy is being installed, install the tether and
pin-type retainer to the A-pillar.
Item 10: C-Pillar Tether Anchor Assembly Installation Note
1. Engage the rear tether anchor assembly hook to the C-pillar sheet metal.
Item 14: Connector Installation Note
1. Remove the restraint system diagnostic tool from the safety canopy electrical connector.
Rivet Nut Replacement
RIVET NUT REPLACEMENT
CAUTION: If the safety canopy module has deployed, the tether cord rivet nut must be inspected and replaced if damaged before installing a
new safety canopy.
NOTE:
-
A typical rivet nut replacement is shown that is similar for all vehicles.
-
The left-hand drive driver side is shown, all others are similar.
1. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
Deactivate the supplemental restraint system (SRS).
2. Remove the A-pillar trim panel.