Aviator 2WD V8-4.6L DOHC (2003)
Install the driver seat.
-
After installation, position the driver seat from its forward most position to its rearmost position and then back again. While positioning the
seat, make sure that the seat position sensor, the magnet and bracket or the wire harness do not come in contact with any other part of the seat
that may cause damage.
3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure
5. Disconnect the battery ground cable and wait at least one minute.
6. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
Reactivate the supplemental restraint system (SRS).
7.
Connect the battery ground cable.
8. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure
to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure
Item 5: Seat Position Sensor Installation Note
1. NOTE: Route the wire harness as noted during removal.
Connect the seat position sensor electrical connector.