Aviator 2WD V8-4.6L DOHC (2003)
Suspension Strut / Shock Absorber: Service and Repair
Removal and Installation
Front
Shock Absorber and Spring Assembly-Front
NOTE: Use the hex holding feature to prevent the stud from turning while removing or installing the stabilizer bar link nut.
1. Remove the wheel and tire assembly.
2. Remove the components in the order indicated in the illustration and table.
3. To install, reverse the removal procedure.
Item 2: Stabilizer Link Nut Removal Note
1. Have an assistant pry downward on the stabilizer bar to release the tension when removing the nut.
Item 5: Shock Absorber and Spring Assembly Removal Note
1. For additional information on the disassembly and assembly of the shock absorber and spring assembly refer to Shock Absorber and Spring
Assembly.
Item 3: Shock Absorber-to-Lower Arm Bolt Installation Note
1. Do not tighten until the installation procedure is complete and the weight of the vehicle is resting on the wheel and tire assemblies.