Aviator 2WD V8-4.6L DOHC (2003)
7. Install the retainer circlip.
8. For the inboard CV joint, carry out the following:
1
Pack the inboard CV joint housing with 250 grams (8.82 oz.) of grease.
2
Spread any remaining grease evenly inside the boot and CV joint.
3
Install the inboard CV joint housing, seating the boot in the groove in the housing.
9. Set the halfshaft assembled length to specifications.
1
Measure the entire assembly length.
2
Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.
3
Hold the inner joint to prevent the assembled length from changing, and insert a small flat-blade screwdriver between the boot and the joint to
equalize the pressure.