Aviator 2WD V8-4.6L DOHC (2003)
7. Fill the inboard CV joint housing with 210 grams (7.41 oz) of grease.
^
One-half of the grease must be installed in the joint and the remainder placed in the boot.
8. Position the CV housing on the CV joint.
9. Position the inboard halfshaft boot and clamp.
1
Position the boot in the housing groove.
2
Position the boot clamp.
10. Using the special tool, install the boot clamps.
11. CAUTION: On the RH side, check the retainer circlip engagement after reseating the axle shaft and after installing the halfshaft in the axle. On
the LH side, check the retainer circlip engagement after installing the halfshaft in the axle. When seated, the retainer circlip will lock the axle shaft
and the inboard CV joint housing to the axle.
