Aviator AWD V8-4.6L DOHC VIN H (2003)
11.
Place the reinforcement bracket back onto the cross member. Align pre-drilled holes and clamp in place. Secure the reinforcement bracket with
rivets from Kit (Figures 9 and 10).
12.
Check to ensure that none of the rivets are protruding up into the path of the sunshade travel. If necessary flatten rivets on the sunshade side.
13.
Take the DVD mounting bracket and place on a work bench. Using the measurements provided in (Figure 11), accurately lay out the rivet holes to
be drilled. Drill holes using a 1/8" drill bit.
14.
Reinstall DVD mounting bracket being sure to locate the stops of the three (3) tabs against the edge of the cross member slots, it may be necessary
to slightly pry the center front edge. Secure with all screws.
