lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Driver Air Bag Module|Page 8102 > < Driver Air Bag Module
Page 2
background image

The side impact sensors (if equipped) are located at or near the base of the B-pillars and C-pillars.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental

restraint system (SRS) deactivation/reactivation procedure.

NOTE:  Within the Supplemental Restraint System (SRS) Deactivation and Reactivation procedure the driver air bag module is removed and
restraint system diagnostic tools are attached at the appropriate locations.

Deactivate the supplemental restraint system(SRS).

INSTALLATION

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, and notes at the beginning of the removal
procedure.

1. NOTE:  Make sure the battery negative cable is still disconnected before continuing with the installation portion of this procedure.

Install the components in the order indicated in the illustration and table.

2. Connect the battery ground cable.

Driver Air Bag Module|Page 8102 > < Driver Air Bag Module