Aviator AWD V8-4.6L DOHC VIN H (2003)
The side impact sensors (if equipped) are located at or near the base of the B-pillars and C-pillars.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
Disconnect the battery ground cable and wait at least one minute.
2. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental
restraint system (SRS) deactivation/reactivation procedure.
Deactivate the supplemental restraint system (SRS).
3. Remove the B-pillar trim panel.
4. Remove the components in the order indicated in the illustration and table.
INSTALLATION
1. WARNING: The tightening torque of the air bag side impact sensor retaining bolt is critical for correct system operation.
NOTE: Make sure the battery negative cable is still disconnected before continuing with the installation portion of this procedure.
To install, reverse the removal procedure
2. Connect the battery ground cable.
3. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure
4. Disconnect the battery ground cable and wait at least one minute.
5. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
