Aviator AWD V8-4.6L DOHC VIN H (2003)
3. Lubricate the lips of the stub shaft housing bearing seat with rear axle lubricant. Place the seal on the special tool.
4. CAUTION: Installation of the stub shaft housing bearing and seal without the correct tool can result in an early bearing or seal failure. If the
bearing or seal become cocked during installation, remove it and install a new one.
Carefully align the stub shaft housing bearing seal with the housing bore and install the seal.
Item 6: Rear Halfshaft Assembly Installation Note
1. For the outboard CV joint, carry out the following:
1
Slide the boot on the interconnecting shaft.
2
Pack the outboard CV joint with 225 grams (7.93 oz.) of grease.
3
Spread any remaining grease evenly inside the boot.
4
Install the boot by seating it in the groove in the CV joint housing.
2. Using the special tool, install the boot clamps.
