Aviator AWD V8-4.6L DOHC VIN H (2003)
Disconnect the window regulator motor electrical connector and pull the motor through the door opening.
Item 9: Window Motor Removal Note
1. NOTE: The LF window motor must be reinitialized whenever: the motor is removed from window regulator drum housing, a new motor is
installed, a new window regulator is installed, a new window glass is installed, glass top run removal or installation, or when carrying out any
operation in which grease or lubricants are applied to the window system. A new LF window motor will be in a proportional up/down mode until
initialized.
Use a flat-blade screwdriver between the window regulator motor and window regulator assembly to hold the window regulator assembly drum in
place.
Item 11: Glass Top Run Assembly Removal Note
1. NOTE: The LF window motor must be reinitialized whenever: the motor is removed from window regulator drum housing, a new motor is
installed, a new window regulator is installed, a new window glass is installed, glass top run removal or installation, or when carrying out any
operation in which grease or lubricants are applied to the window system. A new LF window motor will be in a proportional up/down mode until
initialized.
Remove the glass top run assembly up through the top opening of the front door.
INSTALLATION
1. To install, reverse the removal procedure.
2. If the work was carried out on the LF door, reinitialize the LF window motor.
Item 3: Rivet Installation Note
1. Lower the front door window glass as necessary to access rivets.
