Continental V8-302 5.0L (1984)
7.
Place second EGR gasket over carbon trap and install EGR valve and retaining nuts. Torque retaining nuts to 12-18 ft.lbs. (16-24 N-m).
Reconnect vacuum hose and electrical connectors.
8.
Remove EGR water inlet connector from intake manifold and install pipe plug (87838-S101 with sealant. Torque to 12-21 ft.lbs. (16-28
N-m). Install vacuum cap (C9AZ-9C492-A) on three-way tee and secure with a new clamp (C9AZ-8287-A).
9.
Start engine and check for coolant, exhaust or vacuum leaks.
10.
Test drive vehicle.
NOTE:
If detonation (ping) is present, retard ignition timing in 2~ increments until detonation is gone. Do NOT exceed a maximum of 6~
below required specification. Obtain Ford Authorized Modifications Decal if timing is changed.
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of alterations performed. Select a prominent place
adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the
decal, and cover it with a clear plastic decal shield.
PART NUMBER
PART NAME
CLASS
E5DZ-9D476-A
EGR Gasket
B
E7PZ-9F464-A
Carbon Trap - Cast Iron
C
Intake Manifold
E7PZ-9F464-B
Carbon Trap - Aluminum
C
Intake Manifold
87838-S101
Pipe Plug
BR
C9AZ-9C492-A
Vacuum Cap
A
C9AZ-8287-A
Clamp
AG
OTHER APPLICABLE ARTICLES: 86-2-22
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual
OPERATION: SP870115A
TIME:
1.5 Hr. DLR. CODING: Basic Part No. 9F483 - Code: N9