Continental V8-302 5.0L (1984)
Power Steering Pump: Service and Repair
Removal and Installation
1.
Disconnect fluid return hose at reservoir and drain power steering fluid into a container.
2.
Remove pressure hose from pump fitting. Do not remove fitting from pump.
3.
Disconnect belt from pulley. If necessary, remove pulley from pump installing pulley remover tool T75L-3733-A or equivalent so small diameter
threads engage in pump shaft. While holding small hex head, rotate tool nut to remove pulley. Do not apply in and out pressure on pump shaft as
this will damage the internal thrust areas.
4.
Remove pump.
5.
If pulley was removed, install tool and while holding small hex head, turn tool nut clockwise to install pulley. Pulley must be flush within .010 inch
of the end of the pump shaft. Do not apply in and out pressure on shaft. Remove tool.
