Continental V8-302 5.0L (1984)
Figure 18
2.
After removal of the #3 crossmember assembly, remove items A, B, and C from the right hand side only as shown on Figure 18.
3.
Re-position the R.H. crossmember bushing item D so that the hole in the bushing is centered with the hole in the crossmember. Re-assemble items
B, C, and A.
4.
Elongate the two holes in-line in the R.H. member -transmission support 4 mm (.160") outboard as shown in View "A" of Figure 18. (Right hand
side only.)
5.
Install the #3 crossmember assembly back into the vehicle. (Refer to Shop Manual Page 21-21-8, Figure 15.) While installing the #3 crossmember,
the vertical bolts must be torqued before the horizontal bolts through the transmission support brackets.
ARTICLE SUPERSEDED: 84-6-20
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP5059B84