Continental V8-302 5.0L (1984)
Suspension Strut / Shock Absorber: Service and Repair
Rear
MARK VII & 1982---87 CONTINENTAL
On 1984---88 vehicles, turn air suspension switch off before replacing shock absorber.
1.
Open trunk to gain access to upper shock absorber attachment.
2.
Remove rubber cap if equipped, from shock absorber stud, then remove nut, washer and insulator.
3.
Raise vehicle and support rear axle.
4.
Remove lower shock absorber protective cover, then remove cross bolt and nut from lower shock absorber mounting bracket.
5.
From underneath vehicle, compress shock absorber to clear hole in upper shock tower, then remove shock absorber. These models are equipped
with gas pressurized shock absorbers which extend unassisted during removal. Do not apply heat or flame to the shock absorber tube
during removal.
6.
Reverse procedure to install. While holding shock absorber in position, torque lower cross bolt to 59 ft. lbs. Lower vehicle and install upper
mounting nut, washer and insulator and torque nut to 24 to 26 ft. lbs.
