Continental V8-302 5.0L (1984)
FIGURE 4
13.
Drill three (3) 11/64" (4.3 mm) holes in the center punched cowl top panel.
14.
Raise windshield sight shield and position the other new service reinforcement with two (2) holes on the cowl top panel, Figure 4.
15.
Using the two (2) holes in the reinforcement, center punch the cowl top panel.
NOTE:
The reinforcement must be positioned 1-1/2" (37 mm) inboard from the edge of the cowl top panel.
16.
Drill two (2) 11/64" (4.3 mm) holes in the center punched cowl top panel.
17.
Spray a rust fighter inside the cowl area where five (5) holes have been drilled. Wipe off excess rust fighter that appears on the outside surface of
the cowl top panel.
FIGURE 5
18.
Position the new wiper pivot mounting bracket and the two (2) reinforcements to the cowl top panel, Figure 5.
