Continental V8-4.6L DOHC (1995)
Trim Panel: Service and Repair
Rear
Removal and Installation
1. Using a small screwdriver, remove the screw cover from the armrest of rear door trim panel.
2. Remove the two retaining screws.
3. Using Trim Pad Removing Tool from Rotunda Moulding/Trim kit 107-00401 or equivalent, pry rear door trim panel from door inner panel.
4. Disconnect electrical connectors.
5. To install, position rear door trim panel on door inner panel aligning two locators on rear door trim panel and reverse Removal procedure. Tighten
screws to 1.6-2.2 N-m (1.5-2 lb-ft).