Continental V8-4.6L DOHC (1995)
Dry fit all of the connectors. Do Not use any conductive lubricant.
5.
Connect jumper harness to fan motor and to existing vehicle wiring harness.
6.
Remove fan shroud retaining screw from upper left corner.
7.
Position fuse holder to upper left corner of shroud and reinstall retaining screw. Tighten to 3.5 - 4.5 N-m (31-41 lb-in). See Figure 1-AA.
8.
Attach existing vehicle wire harness push pin retainer to the newly drilled hole at the top of the fan shroud.
9.
Attach the jumper harness to the existing hole in back of the shroud using the push pin retainer supplied. See Figure 1-AA. Please note that some
models will use only one retainer.
10.
Install resonator, if equipped.
11.
Connect battery negative cable.
12.
Check cooling fan motor for proper operation.
13.
Close hood.
Attachment III - Technical Instructions - Kit BB
Technical Instructions
Engine Cooling Fan Motor Wiring Harness Circuit Protection Modification
Kit BB Designated Vehicles
Vehicles Affected:
1994-1995 3.0L Sable/Taurus (except SHO)
Required Parts:
F43 - Z-14K095-CA
Installation Procedure:
1.
Open hood. Disconnect battery negative cable.
2.
Disconnect existing vehicle wiring harness connector from cooling fan motor. Disconnect wire loom and retainer from fan shroud.
3.
Remove upper left fan shroud retaining nut.
4.
Position fuse holder mounting bracket over retaining stud with fuse in upright position. Reinstall retaining nut and tighten to 3.5-4.5 N-m (31-41
lb-in).
CAUTION
Dry fit all of the connectors. Do Not use any conductive lubricant.
5.
Connect jumper harness to the cooling fan motor and to existing vehicle harness.
