Continental V8-4.6L DOHC (1995)
5.
Reposition and secure cooling fan motor harness to mounting pad located on fan shroud to the right of the original location using existing retainer.
See Figure 1-DD.
6.
Install jumper harness onto fan shroud as shown in Figure 2-DD. Make sure harness is positioned so fuse holder is as far away from retainer as
possible. Refer to Figure 2-DD.
7.
Position fuse holder in place on radiator upper support sheet metal and mark location of the mounting hole. See Figure 2-DD.
CAUTION
The radiator and a wire harness are located directly below the area to be drilled. Position the wire harness out of the way prior to drilling. Use a
drill stop or other device to prevent damage to the radiator.
8.
Position the fuse holder out of the way. Then, using a 9/32 inch drill bit, drill one (1) hole at location marked in Step 7.
NOTE:
