Continental V8-4.6L DOHC (1995)
Fig. 7 Intake Manifold Bolt Removal Sequence
22. Loosen and remove 20 intake manifold to cylinder head retaining bolts and studs in sequence shown.
23. Remove upper intake manifold.
24. Disconnect oil sending unit and EVO sensor, then position aside.
25. Disconnect EGR tube from right exhaust manifold, then lower vehicle.
26. Disconnect 42-pin connector, A/C compressor, HDR sensor and canister purge solenoid.
27. Remove PCV valve from valve cover, then disconnect canister purge vent hose from PCV valve.
28. Disconnect accelerator and speed control cables from throttle body, then remove accelerator cable bracket from intake manifold and position
aside.
29. Disconnect throttle valve cable from throttle body.
30. Disconnect vacuum hose from throttle body adapter port.
31. Disconnect both HEGO sensors and heater supply hose.
32. Remove thermostat housing, then disconnect upper hose and position aside.
33. Remove bolts attaching intake manifold, then the intake manifold and gaskets.
34. Reverse procedure to install, noting the following:
a. Clean cylinder head and intake manifold surfaces.
b. Install new intake manifold gaskets.
