Continental V8-4.6L DOHC (1995)
Side Air Bag: Service and Repair
Driver Side Air Bag Module
REMOVAL
NOTE: If the driver side air bag module did not deploy in a collision, it may not have been needed. Complete all diagnosis before replacing the driver
side air bag module.
1. Record pre-set radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable and wait one minute for backup power supply to deplete its stored energy.
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment
and possible personal injury, the battery ground cable must be disconnected prior to servicing or replacing any system components.
3. Remove two steering wheel spoke covers.
4. Remove two bolt and washer assemblies retaining driver side air bag module to steering wheel.
5. Disconnect the air bag electrical connector from air bag sliding contact connectors. Remove driver side air bag module.
WARNING: Place air bag module on bench with trim cover facing up to avoid possible personal injury.
INSTALLATION
NOTE: Fill out and return air bag traceability postcard for new air bag with VIN numbers and note diagnostic trouble code.
1. Connect the driver side air bag module wiring connector to air bag sliding contact connector.
2. Position driver side air bag module to steering wheel and secure with two bolt and washer assemblies. Tighten screws to 10.2-13.8 Nm (90-122 in
lbs).
