Continental V8-4.6L DOHC (1995)
Seat Belt: Service Precautions
WARNING:
-
Children having a seating height greater than 71 cm (28 inches) should use the safety belts provided with the vehicle. However, the
shoulder belt portion of the lap/shoulder safety belt should not be used if it contact the child's face, chin, neck, or throat.
-
If the shoulder portion of the safety belt either touches or hangs in front of the child's face, chin, neck, or throat, move the child closer to
the center of the vehicle or use a booster seat to help provide a good shoulder belt fit.
-
If the shoulder belt still does not fit, move the child to a seat with a lap belt only. If the safety belts are not adjusted properly, the child's
chances of being injured in a collision increase.
-
All vehicle occupants, including pregnant women, should wear safety belts for maximum protection in the event of a collision. All vehicle
occupants, including pregnant women, should be sure the lap safety belt, or lap safety belt portion of the lap/shoulder belt, is fitted snugly
and as low as possible around the hips, not the waist. Failure to properly use the safety belts may increase the chances and/or severity of
injury in the event of a collision.
-
According to accident statistics, properly restrained children are safer in the rear seat than in the front seat. For young children, infant
and child restraints should be obtained and used in accordance with the instructions provided by the manufacturer of the infant and child
restraint. Child restraint use is required by law.
-
Never install a rear facing child safety seat or infant carrier in the front seat.
-
All safety belt assemblies including retractors, buckles, front safety belt buckle support assemblies (slide bar), if equipped, child safety
seat tether bracket assemblies (if equipped) and attaching hardware should be inspected after any collision. All safety belt assemblies
should be replaced unless a qualified technician finds that the assemblies show no damage and operate properly. Safety belt assemblies
not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
-
Do not bleach or re-dye the webbing, as webbing may weaken.
-
Slide the shoulder belt height adjuster up or down until the belt rests across the middle of your shoulder. If the shoulder belt is off your
shoulder, on your upper arm, or neck, there is a greater risk of severe injury in a collision. Be sure the shoulder belt is properly
positioned on your shoulder each time you use the belt.
-
Do not introduce slack into the safety belt system because the belt locks upon impact where it is positioned. Use the shoulder safety belt on
the outside shoulder only. Never wear the shoulder belt under the arm. Never swing it around the neck over the inside shoulder. Never
use a single belt for more than one person. Make sure the lap portion of the belt is fitted snugly and as low as possible around the hips,
not on the waist. Failure to follow these precautions could increase the chance and/or severity of injury in a collision.
