Continental V8-4.6L DOHC (1995)
Fig. 2 Interconnecting Shaft Identification
7. The lefthand and righthand interconnecting shafts are not the same end-for-end. The outboard end is shorter from end of shaft to end of boot
groove than the inboard end. Take a measurement to ensure proper inboard and outboard CV joint to shaft installation.
8. If removed, install CV joint boot after removing stop ring.
9. Ensure boot is properly seated in its groove and clamp into position.
10. If removed, install stop ring. If not removed, ensure stop ring is properly seated in groove.
11. Install a new snap ring, supplied with service kit, in groove nearest end of shaft.