Continental V8-4.6L DOHC (1995)
Installation
1. Position the window regulator electric drive to the regulator and install the three screws snug--not tight.
2. Connect the window regulator electric drive wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged,
tighten the three window regulator electric drive retaining screws to 5.6-9.6 N-m (50-84 lb-in).
3. Connect battery ground cable.
4. Check power window for proper operation.
NOTE: Verify that all drain holes at bottom of doors are open to prevent water accumulation over window regulator electric drive.
5. Install door trim panel and watershield.
