Continental V8-4.6L DOHC VIN V (1998)
Garage Door Opener Transmitter: Service and Repair
Programming
WARNING: A GARAGE DOOR OPENING SYSTEM WHICH CANNOT STOP OR REVERSE ITSELF AFTER DETECTING AN
OBJECT IN ITS PATH, DOES NOT MEET CURRENT FEDERAL SAFETY STANDARDS. TO DECREASE THE RISK OF SERIOUS
INJURY OR DEATH, DO NOT USE THIS HOMELINK TRANSMITTER WITH A DOOR OPENING SYSTEM THAT LACKS STOP AND
REVERSE FEATURES AS REQUIRED BY FEDERAL STANDARDS. THIS INCLUDES ANY GARAGE DOOR OPENING SYSTEM
MANUFACTURED BEFORE APRIL 1,1982. FOR MORE INFORMATION CALL HOMELINK CUSTOMER ASSISTANCE AT
1-800-355-3515.
1. Verify the hand-held transmitter is operative.
CAUTI0N: During this procedure, the system that you are programming will be made to operate. Make sure that people or objects are clear of the
garage door or gate being programmed.
2. Hold down the two outside buttons on the universal transmitter until the red light begins to flash. Release both buttons.
3. Select one of the three universal transmitter channels to be programmed by depressing the desired button.
4. Hold the end of the hand-held transmitter against the front surface of the universal transmitter so that the red light can still be seen.
5. Use both hands to press the hand-held transmitter button and the desired button on the universal transmitter. Do not release either button.
NOTE: During programming, the hand-held transmitter may automatically stop transmitting after two seconds, which may not be long enough to
program the universal transmitter. If programming this type of hand-held transmitter, continue to hold the button on the universal transmitter while
re-pressing the hand-held transmitter button every two seconds.
6. Hold down both buttons until the red light on the universal transmitter flashes, first slowly and then rapidly. Release both buttons when the rapid
flashing begins. The universal transmitter has successfully learned the new frequency signal and can be used in place of the hand-held
transmitter(s).
7. To operate, simply press the appropriate button on the universal transmitter. The red light is on while the signal is being transmitted.
NOTE: If the hand-held transmitter appears to program the universal transmitter but does not open the garage door, the garage door opener may
have a "code protected" or "rolling code" feature.
