Continental V8-4.6L DOHC VIN V (1998)
4. Connect the engine control sensor wiring to the engine coolant temperature sensor.
5. Connect the hoses to the bypass tube.
6. Position the generator bracket.
7. Install the bolts and the nuts.
8. Connect the harness retaining clip to the generator mounting bracket.
9. Close the radiator draincock and f°11 engine cooling system.
CAUTION: Use extreme care to keep coolant mixture off accessory drive pulleys. If needed, remove the drive belt and rinse with clear water.
Clean the pulleys and install the drive belt. Drive belt squeal and early drive belt fatigue will occur otherwise.
10. Start engine and check for leaks.
