Continental V8-4.6L DOHC VIN V (1998)
Audible Warning Device: All Technical Service Bulletins
Ignition Switch - High Turning Effort/MIL ON/DTC's Set
Article No.
01-21-13
10/29/01
^
DRIVEABILITY - DIAGNOSTIC TROUBLE CODES
(DTC) P0500, P1502 AND/OR U1039 CONTINENTAL
MODELS ONLY - STICKING OR BINDING IGNITION
LOCK CYLINDER - HIGH EFFORT WHEN TURNING
IGNITION SWITCH
^
ELECTRICAL - STICKING OR BINDING IGNITION
LOCK CYLINDER - HIGH EFFORT WHEN TURNING
IGNITION SWITCH
FORD:
1998-2002 CROWN VICTORIA, MUSTANG, TAURUS
1998-1999 F-250 LD
1998-2001 EXPLORER
1998-2002 E SERIES, EXPEDITION, F-150, RANGER, WINDSTAR
1999-2002 SUPER DUTY F SERIES
2000-2002 EXCURSION, EXPLORER SPORT
2001-2002 EXPLORER SPORT TRAC
LINCOLN:
1998-2002 CONTINENTAL, TOWN CAR, NAVIGATOR
2002 BLACKWOOD
MERCURY:
1998-2002 GRAND MARQUIS, SABLE
1998-2001 MOUNTAINEER
ISSUE
Some ignition switch lock cylinder assemblies may exhibit the following highly intermittent conditions:
^
Roughness and/or excessive effort in turning the key from RUN to START position.
^
Key does not fully return from START to RUN after starting vehicle. This may result in intermittent accessory function.
^
Continental ONLY - A malfunction indicator lamp may illuminate with diagnostic trouble codes P0500, P1502 and UlO3g stored in the Powertrain
Control Modules (PCM) memory.
This may be caused by a Key-In-Ignition warning chime switch.
ACTION
Replace the KEY-IN-IGNITION WARNING CHIME SWITCH located on the ignition switch lock cylinder with revised pant XL2Z-11A127-AB. Refer
to the following Service Procedure for details.
SERVICE PROCEDURE
1.
Disconnect the battery ground cable and wait at least one minute.
2.
Insent the ignition key and turn it to the RUN position.
3.
Insert a punch into the access hole (located in the lower steering column shroud, below the lock cylinder) and press the release button while
pulling out the ignition switch lock cylinder.
NOTE
SOME VEHICLES DO NOT HAVE AN ACCESS HOLE AND REQUIRE LOWER SHROUD REMOVAL. REFER TO THE APPROPRIATE
MODEL WORKSHOP MANUAL, IGNITION SWITCH LOCK CYLINDER REMOVAL AND INSTALLATION SECTION 211 IF
ADDITIONAL DETAIL IS REQUIRED.
