Continental V8-4.6L DOHC VIN V (1998)
Power Door Lock Control Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
CAUTI0N: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
2. Remove the front door trim panel.
3. Disconnect the electrical connectors from the Driver Door Module (DDM).
4. Release the retaining clips and remove the DDM.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
2. Program the keyless entry keypad codes and keyless entry remote transmitters.
