Continental V8-4.6L DOHC VIN V (1998)
Steering Gear: Service and Repair
Installation
1. Position the steering gear in the vehicle.
2. Replace the return line connector seal and the pressure line connector seal.
-
Use the Seal Replacer to install the seals over the fittings.
3. Connect the pressure and return lines.
4. Position the steering gear on the subframe, and install the retaining nuts.
5. Connect the wiring at the steering gear.
6. Position the heat shield bracket, and install the retaining screws.
7. Position the heat shield, and install the pushpins.
8. Raise the lift.
