Continental V8-4.6L DOHC VIN V (1998)
5. Remove the No. 16 final drive gear thrust washer.
6. Using an air nozzle, apply 40 psi of regulated air to the low intermediate apply port to remove the piston and seal assembly.
WARNING: TO PREVENT INJURY, WEAR EYE PROTECTION WHEN USING PRESSURIZED AIR.
NOTE: The seal is part of the piston and is serviced as an assembly.
7. Using the Collet, actuator pin, and Impact Slide Hammer remove the rear rear lube oil transfer tube seal.
CAUTION: Use care not to damage any machined surfaces.
8. Repair as required.
NOTE: If the bushing is worn or the fluid passage is blocked the rear rear planet support should be replaced.
ASSEMBLY
