LS V8-3.9L VIN A (2003)
7.
Apply a small bead (approximately 1/8" wide) of 3M DP-810 NS adhesive to the CHMSL (failed adhesive) side of the Dual Lock Fastener that
was removed in Step 4. Refer to (Figure 1) for proper adhesive bead pattern.
CAUTION
DO NOT APPLY TOO MUCH ADHESIVE OR IMPROPER REPAIR MAY RESULT.
8.
Align Dual Lock Fastener with "L" shaped locator on CHMSL and install. Applying pressure, hold Dual Lock Fastener to CHMSL for 1 (one)
minute. Refer to (Figure 2).
9.
Immediately wipe off any excess adhesive material expelled around edges of Dual Lock Fastener.
CAUTION
DO NOT GET ANY ADHESIVE MATERIAL ON THE HEADLINER SIDE OF THE DUAL LOCK FASTENER THAT IS BEING ATTACHED
TO THE CHMSL OR IMPROPER REPAIR MAY RESULT.
10.
Allow adhesive to cure for 1 (one) hour before proceeding to Step 12.
11.
Reattach Headliner to the CHMSL Dual Lock Fastener. Apply pressure for 1 (one) minute.
