LS V8-3.9L VIN A (2003)
1. CAUTION: Damage will occur to the solenoid body assembly if the screw is tightened above the specification.
NOTE: Always install new O-ring seals on vehicle harness connector. Clean the area around connector to prevent contamination of the solenoid
body connector. Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.
Install and lubricate new O-ring seals on the transmission connector and connect the connector.
Item 3: Heated Oxygen Sensor Electrical Connector Retainer Installation Note
1. Install the heated oxygen sensor connector from the front of the transmission pan rail.
Item 2: Heated Oxygen Sensor Electrical Connector Installation Note
1. Connect the heated oxygen sensor connector and install the sensor wire retaining clip to the right side of the transmission pan rail.