LS V8-3.9L VIN A (2003)
1. Remove the heated oxygen sensor connector from the front of the transmission pan rail.
Item 7: Transmission Range TR Sensor Electrical Connector Removal Note
1. Remove and discard the tie strap front the digital TR sensor connector boot.
2. Slide the rubber boot back and disconnect the digital TR sensor connector.
Item 16: Solenoid Body O-Ring Seals Installation Note
1. Install new O-ring seals on the solenoid body connector. Lubricate the O-ring seals with clean automatic transmission fluid.
Items 13 and 14: Solenoid Body Screws Installation Note
1. CAUTION: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If it is damaged, transmission leak
may occur.
Install the solenoid body. Tighten the screws in sequence shown.
