Mark LT 2WD V8-5.4L (2008)
-
If passenger seat, disconnect the belt tension sensor (BTS) electrical connector.
14. If equipped, disconnect the power seat track electrical connector and release any pin-type retainers attached to the seat cushion frame.
15. If equipped, disconnect the 3 memory seat position sensor electrical connectors (1 shown) and detach the wiring harness from the cushion frame.
16. If equipped with manual lumbar, release the rear inboard cushion trim cover J-clip and note the lumbar cable routing for installation.
17. Remove 4 nuts and cushion frame.
-
To install, tighten to 25 Nm (18 lb-ft).
-
Disconnect and detach all remaining electrical connectors and pin-type retainers attached to the seat cushion frame.
18. Release the cushion trim cover J-clips.
