Mark LT 2WD V8-5.4L (2008)
Parking Brake Shoe: Service and Repair
Parking Brake Shoes
Material
Drum Brake System (1 Of 2)
Drum Brake System (2 Of 2)
Removal
NOTE: One parking brake shoe kit contains the linings required for both the LH and RH side.
1. NOTE: Make sure the parking brake control is fully released.
Relieve the tension on the parking brake cable.
2. Remove the rear brake disc.
3. Remove the brake shoe adjuster screw.
4. Remove the brake shoe adjuster screw spring.
5. Remove the 2 brake shoe hold-down springs and 2 pins.
6. Remove the brake shoe retracting spring and the parking brake shoes.
Installation
1. NOTE: Lubricate the parking brake shoes where the shoe contacts the wear pad on the backing plate.
Position the parking brake shoes and attach the retracting spring.
2. Install the 2 brake shoe hold-down pins and springs.
3. Install the brake shoe adjusting screw spring.