Mark LT 2WD V8-5.4L (2008)
2. CAUTION: When installing the valve cover, make sure to avoid damaging the variable camshaft timing (VCT) solenoid.
Position the LH valve cover and new gasket on the cylinder head and tighten the fasteners in the sequence shown.
^
Tighten to 10 Nm (89 lb-in).
3. Position the intake manifold vacuum tube assembly onto the support bracket and the valve cover stud.
4. Connect the VCT solenoid electrical connector and the wiring harness retainers.
5. Connect the radio ignition interference capacitor electrical connector.
6. Position the PCV tube and connect the quick connect couplings.
7. Connect the intake manifold vacuum tube hose to the brake booster.
8. Position the power steering reservoir and bracket assembly and install the bolt.
^
Tighten to 25 Nm (18 lb-ft).
9. Install the power steering reservoir and bracket assembly nut.
^
Tighten to 10 Nm (89 lb-in).
10. Install the oil level indicator and tube.
11. Install the LH ignition coils.
12. Install the air cleaner intake pipe.
