Mark LT 2WD V8-5.4L (2008)
Headlamp Bulb: Service and Repair
HEADLAMP BULB
Removal and Installation
WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle
the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
NOTE:
-
The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period
of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn
on the headlamp with the bulb removed from the headlamp.
-
Make sure that the headlamp switch and the ignition switch are in the OFF position.
1. Remove the headlamp assembly.
2. Rotate the headlamp bulb approximately 1/8 turn counterclockwise and remove the bulb from the headlamp assembly.
3. To install, reverse the removal procedure.
