Mark LT 2WD V8-5.4L (2008)
Removal and Installation
WARNING:
-
When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP
system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this
instruction may result in serious personal injury.
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
1. Remove the fuel tank.
2. Disconnect the 2 fuel vapor tube assembly-to-fuel pump module quick connect couplings.
3. Remove the fuel vapor tube assembly.
4. To install, reverse the removal procedure.
