Mark LT 2WD V8-5.4L (2008)
1. Install the seat cushion trim cover.
-
Install hog rings to attach the seat cushion trim cover to the seat cushion foam pad of the OCS assembly at all locations from where they were
removed.
2. At the front outboard side of the seat cushion frame, attach the 2 clips.
3. On vehicles equipped with SIR seats, attach the seat cushion trim cover J-clips to the seat cushion frame.
-
If equipped with manual lumbar, do not attach the rear inboard J-clip at this time.
4. Install the seat cushion assembly and the 4 nuts to the seat track.
-
Position the safety belt buckle through the seat cushion strap.
-
Tighten to 25 Nm (18 lb-ft).
5. If equipped, connect the backrest heated seat element electrical connector and attach any wire harness retainers to the seat cushion frame.
6. If equipped, connect the power seat track electrical connector and attach any wire harness retainers to the seat cushion frame.
7. NOTE: If equipped with manual lumbar, make sure this wire harness is routed above the manual lumbar cable.
Connect the safety belt buckle pretensioner and safety belt buckle switch electrical connectors and attach the wire harness retainer to the seat track.
8. CAUTION: To prevent component damage and avoid setting DTCs, the following precautions must be taken:
-
The position assurance locking wedge must be in the released position when inserting the electrical connector in the safety belt buckle
and pretensioner.
-
Do not install the electrical connector by pushing on the position assurance locking wedge.
-
Make sure the electrical connector and position assurance locking wedge are fully seated after connecting to the safety belt buckle and
pretensioner.
Fully engage the locking wedge on the safety belt buckle and pretensioner electrical connector.
