Mark LT 2WD V8-5.4L (2008)
9. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be
torn from the backrest foam pad.
Invert the backrest trim cover and remove the row of hog rings.
-
Release the hook-and-loop strips and separate the backrest trim cover from the foam pad.
10. Remove the hog rings on the back of the backrest foam pad and remove the backrest trim cover.
11. Remove the backrest foam pad from the backrest frame.
12. Remove the safety belt retractor bolt and the safety belt retractor.
-
To install, tighten to 55 Nm (41 lb-ft).
13. Release the safety belt retractor upper guide from the backrest frame.
14. To install, reverse the removal procedure.
15. Install the front seat backrest.
16. Install the affected seat.
17. Check the active restraint system for correct operation.
