Mark LT 2WD V8-5.4L (2008)
Seat Position Sensor: Service and Repair
Seat Position Sensor - Power Seat Track
SEAT POSITION SENSOR - POWER SEAT TRACK
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. NOTE: The seat position sensor is mounted at the LH rear of the seat track. Position the driver seat rearward enough so that upon removal the
sensor can clear the bracket.
Position the driver seat to access the seat position sensor.
2. Depower the SRS.
3. Fold the seat backrest all the way forward.
4. Disconnect the seat position sensor electrical connector.
5. Remove the nuts and seat position sensor.
-
To install, tighten to 8 Nm (71 lb-in).
6. To install, reverse the removal procedure.
7. Repower the SRS.
