Mark LT 2WD V8-5.4L (2008)
Part 2
Removal and Installation
1. CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the
power steering components may result.
With the vehicle in NEUTRAL, position it on a hoist.
2. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
3. Release the power steering fluid cooler-to-reservoir hose clamp and disconnect the hose from the power steering fluid reservoir.
4. Remove the steering line clamp plate bolt, rotate the clamp plate and disconnect the power steering fluid cooler from the steering gear.
^
To install, tighten to 23 Nm (17 lb-ft).
5. Remove the 2 power steering fluid cooler bolts and the cooler.
^
To install, tighten to 11 Nm (8 lb-ft).
6. To install, reverse the removal procedure.
^
Fill the power steering system.