Mark LT 2WD V8-5.4L (2008)
3. Remove and discard the stabilizer bar link lower nut.
4. Remove and discard the shock absorber lower nut and bolt.
5. Remove the lower arm nuts, bolts and the lower arm.
^
Discard the nuts and bolts.
Installation
NOTE: Use the holding feature to prevent the ball studs (lower ball joint and stabilizer bar link) from turning while installing the nuts.
1. NOTE: Do not tighten the lower arm nuts at this time.
Install the lower arm and loosely install the lower arm bolts and nuts.
2. Position the lower ball joint into the wheel spindle and install the nut.
^
Tighten to 150 Nm (111 lb-ft).
3. Install the shock absorber lower nut and bolt.
^
Tighten the nut to 475 Nm (351 lb-ft).
4. Install the stabilizer bar link lower nut.
^
Tighten to 90 Nm (66 lb-ft).
5. Install the wheel and tire.
6. With the weight of the vehicle resting on the wheels and tires, tighten the lower arm nuts to 350 Nm (258 lb-ft).
7. Check and, if necessary, align the front end.
