Mark LT 2WD V8-5.4L (2008)
7. CAUTION: Tightening one screw before tightening the other may cause the digital transmission range (TR) sensor to bind or become
damaged.
Tighten the digital TR sensor bolts.
^
Tighten to 9 Nm (80 lb-in).
8. Install the manual control lever.
1
Position the manual control lever.
2
Install a new manual control lever nut.
^
Tighten to 33 Nm (24 lb-ft).
9. Connect the digital TR sensor electrical connector.
10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to
click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the
selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable
end is correctly installed.
Connect the selector lever cable end to the manual control lever with the lever in the (D) position.
