Mark LT 2WD V8-5.4L (2008)
Valve Body: Removal and Replacement
Main Control Valve Body
Removal
1. Drain transmission fluid and remove the transmission fluid pan and filter.
2. CAUTION: Do not pull on the molded lead frame. This may cause damage to the connector ends. Carefully pry up on the locking tabs to
disconnect the solenoids. Disconnect the molded lead frame from the solenoids.
Disconnect the molded lead frame from the solenoids.
1
Disconnect the shift solenoid SSA and SSB.
2
Disconnect the torque converter clutch (TCC).
3
Disconnect the electronic pressure control (EPC) solenoid.
4
Disconnect the bulkhead inter-connector.
3. Remove the manual control valve detent lever bolt and spring.
