Mark LT 2WD V8-5.4L (2008)
6. Remove the main control valve body cover plate.
1
Remove the 13 main control valve body cover plate bolts.
2
Remove the main control valve body cover plate.
Assembly
CAUTION: Before beginning assembly, carry out and inspect the following:
When building up subassemblies and assembling the transmission, ALWAYS use new gaskets and seals.
All fasteners must be tightened to the torque specification indicated. In addition to appearing in the section, the necessary torque
measurements can be found in the General Specifications Chart.
When building up subassemblies, each component part should be lubricated with clean transmission fluid. It is also good practice to lubricate
the subassemblies as they are installed in the case.
Needle bearings, thrust washers and seals should be lightly coated with clean transmission fluid during subassembly buildup or transmission
assembly.
Many components and surfaces in the transmission are precision machined. Careful handling during disassembly, cleaning, inspection and
assembly can prevent unnecessary damage to machined surfaces.
NOTE: Inspect the shift solenoid O-rings and TCC solenoid O-rings for damage.
